Siemens simatic hmi op7, Equipment Manual

Page: 145 / 196

B-3
Equipment Manual OP7, OP17
Release 04/99
Mes-
sage Cause Remedy:
005 Internal error:
Error message returned if nothing configured for
a system message
006 Error during data transfer in download mode.
Two variables are transferred with this message
which contain information about the function in
which the error has occurred (variable 1) and the
cause of the error (variable 2).
Variable 1:
0
Initialize function
1 Receive data
2 Send data
3 Send message block
4 Terminate function
Variable 2:
1
Internal error
3 Timeout error
5 Parity error
6 Framing error
7 Overrun error
8 Break in line
9 Receive buffer overflow
10 Control character error when receiving
11 Logging error
Repeat data transfer after first chek-
king the physical connection if ne-
cessary.
040 Driver error
If FAP is set, the character delay time setting may
be too short.
Check physical connection with
PLC.
Modify character delay time.
041 Fault in connection with PLC.
Possible causes:
– Fault on the transmission link, e.g. connecting cable
defective
– Incorrect interface parameters set on OP or on com-
munication peer.
045 No connection with PLC established. Set different CPU under ”PLC –>
Parameters”.
100 Restart due to RAM failure.
101 Restart following termination of COM-UNI mode
103 Startup following cancellation of COM-UNI
mode
104 Transfer cancelled by operator. Connection with
OP is still open, the OP is waiting.
105 Fault resulting in wait message has been elimina-
ted.
107 Restart following activation of COM-UNI mode
108 OP is in download mode.