Siemens SIMATIC FS600, Instruction Manual

Page: 37 / 110

37
5.4.4.1 Recessed installation (undercut) under the machine table
The undercut must be at least as deep as the zone not monitored by the detection zone
lateral to and in front of the scanner. The minimum depth Z
UMIN
is 135 mm. If it is
possible to recess the scanner, this is allowed up to a maximum of 40 mm; the depth of
the undercut is reduced by the depth value of the recess. If the mounting system is being
used, the necessary dimensions of the undercut depth must be increased accordingly
(see Chapter 14.13 and 14.14). The height of the undercut must be limited to prevent
people from being able to step beneath it.
Machine (side view) Machine (view from above)
a = SIMATIC FS600 Laser Scanner S = Safety distance
b = Machine S
B
= Entire width of the
c = unmonitored zone S
T
= detection zone
d = Detection zone Z = detection zone additions
e = Height of the undercut Z
UMIN
= depth of the undercut
f = Mounting surface
g = Scanning plane
Fig. 5.4-1: Recessed scanner installation with undercut
The additional safeguarding required for the particular application must be taken into
account.
Please note that the undercut must cover any unmonitored zones.
e
g
Z
UMIN
b
a
f
b
d
Z
S
a
S Z
UMIN
c
c
S
B
S
T