Siemens SIMATIC FS600, Instruction Manual

Page: 106 / 110

106
15 Diagnostic Codes and Causes
Loca-
tion Description No. Description
102 Processing of commands,
processing of messages 2 Data transmission error on the X2
interface
103 Control of command
processing 2 Data transmission error on the X2
interface
104 Processing of commands,
Processing of configuration 2 Data transmission error on the X2
interface
105 Processing of commands,
generation of output
messages 6 Function, access, command not
permitted with currently selected
authorization level
201 Processing of the receive
protocol 4 Too much data sent over the X2
interface. Message will be
overwritten by new message
302 Processing of the transmit
protocol 2 The verification of displayed data
remained unacknowledged for too
long.
306 Output of measurement
values 5 Previous message not yet
completely output
801 Event processing 2 Event memory cannot be read,
internal fault
805 Processing of the commands
to the event memory 6 Event memory cannot be
transferred. Data transmission error
on interface X2
1002 Motor control during
initialization 1 Motor does not reach rated speed
after start. Internal fault.
1002 Motor control during
initialization 2 Motor speed not constant after start.
Internal fault.
1110 Test of the switch outputs. 4 Switch outputs (OSSD) have
a state other than the one the
scanner expected. Possible wiring
or control error
1110 Test of the switch outputs. 5 Switch output (OSSD) cannot be
switched off
1110 Test of the switch outputs. 6 Switch output (OSSD) cannot be
switched on
1111 Short circuit test of switch
outputs 7 Short circuit of a switch output
(OSSD) with ground
1111 Short circuit test of switch
outputs 8 Short circuit of a switch output
(OSSD) with Vcc
1606 Motor speed monitoring 4 Motor speed deviation, zero pulse
not detected properly,
internal fault
1607 Monitoring of duration
of a scan 5 Motor speed deviation, motor not at
rated speed