Siemens SIMATIC EM 148-FC, Manual

Page: 34 / 76

Commissioning and Diagnostics
3-10
EM 148-FC Frequency Converter
A5E00065321-03
Channel-specific error messages
You can find more information on the channel-specific diagnosis in Chapter 5 of the
ET 200X Distributed I/O Device manual.
Table 3-4 Error messages in accordance with the PROFIBUS standard
Error number Error text Meaning/possible causes Remedy
00010
B
2
D
Undervoltage No supply voltage or supply
voltage too low Check and, if necessary, adjust
the supply voltage
00011
B
3
D
Overvoltage Supply voltage too high Check and, if necessary, adjust
the supply voltage
Braking power too high Increase Ramp-down time
parameter
00100
B
4
D
Overload Overtemperature in the frequency
converter Check the ambient temperature
Overcurrent to the motor Check the mechanical load of the
motor
01001
B
9
D
Error/fault Internal module fault Replace the frequency converter
Table 3-5 Vendor-specific error messages
Error number Error text Meaning/possible causes Remedy
10000
B
16
D
Parameter Module was not parameterized. Reparameterize the module
assignment
error
The module received incorrect
parameters Check all the parameters/motor
data and correct, if necessary
10001
B
17
D
No load voltage
(see note
above) The following voltage is not
applied:
24 VDC load voltage
Adjust the process wiring
11000
B
24
D
Actuator error Overtemperature of the motor Check the mechanical load on the
motor (e.g. brake, load)
The thermistor is not connected Connect the thermistor or disable
the Thermistor monitoring of
motor parameter