Siemens SENTRON PROFINET Proxy SPP2000, Manual

Page: 53 / 90

Data traffic
6.3 Acyclic data traffic
PROFINET Proxy SPP2000
Equipment Manual, 03/2022, L1V30814715D-01
51
6.3.7 DS93 commands
Data set DS93 contains command information.
This data set only applies to the SENTRON PAC devices. The corresponding slot/subslot
address must therefore be used for reading.
Table 6- 11 Structure of data set DS93 – write access only
Byte Bit
positi
on
Lengt
h
(bits)
Format Description PAC
2200
PAC
2200
MID
PAC
2200
CLP
PAC
3200T
SPP
2000
0 16 Unsigned16 Reserved (number of commands)
2 0 1 Bit Reset the maximum values
1)
✓
2 1 1 Bit Reset the minimum values
1)
✓
2 2 1 Bit Reset the energy counter
1)
✓
2 3 1 Bit Acknowledge diagnostics bits
1)
✓ ✓ ✓ ✓
2 4 1 Bit Load profile synchronization
1)
✓ ✓ ✓
2 5 1 Bit Reserved
2 6 1 Bit Reserved
2 7 1 Bit Reserved
3 0 1 Bit Switch tariff (high tariff)
2)
✓ ✓ ✓ ✓
3 1 1 Bit Switch tariff (low tariff)
2)
✓ ✓ ✓ ✓
3 2 1 Bit Switch outputs (if parameterized)
2)
✓ ✓ ✓ ✓
3 3 1 Bit Reserved
3 4 1 Bit Reserved
3 5 1 Bit Reserved
3 6 1 Bit Reserved
3 7 1 Bit Reset the daily/monthly energy counter
memory
1)
✓ ✓ ✓
4 0 1 Bit Reset the device to factory settings
1)
✓ ✓ ✓
4 1 1 Bit Reset device (without changing the IP
address)
1)
✓ ✓ ✓
4 2 1 Bit Reset SPP2000 to factory setting 1) ✓
4 3 1 Bit Reserved
4 4 1 Bit Reserved
4 5 1 Bit Reserved
4 6 1 Bit Reserved
4 7 1 Bit Reserved
5 8 Unsigned8 Reserved
Total
bytes:
6
1) "1" means: The action is executed.
"0" means: The action is not executed.
2) If present and parameterized.
"1" means: Signal = 1
"0" means: Signal = 0