Chapter 3
Device Management
RUGGEDCOM RS910W
Installation Guide
20
Configuring the Device
1
5
9
6
Figure 10: Serial DB9 Console Port
Pin
Name
Description
1
a
Reserved (Do Not Connect)
2
TX
Transmit Data
3
RX
Receive Data
4
a
Reserved (Do Not Connect)
5
GND
Signal Ground
6
a
Reserved (Do Not Connect)
7
b
Reserved (Do Not Connect)
8
b
Reserved (Do Not Connect)
9
Reserved (Do Not Connect)
a
Connected internally.
b
Connected internally.
Ethernet Ports
Connect any of the available Ethernet ports on the device to a management switch and access the RUGGEDCOM
ROS console and Web interfaces via the device's IP address. The factory default IP address for the RUGGEDCOM
.
For more information about available ports, refer to
Section 3.2
Configuring the Device
Once the device is installed and connected to the network, it must be configured. All configuration management
is done via the RUGGEDCOM ROS interface. For more information about configuring the device, refer to the
RUGGEDCOM ROS User Guide
associated with the installed software release.
