²
Configure the jumper settings prior to installation.
²
Push in the new plug-in module on the inner guide as far as it is possible.
²
Connect the leads to the terminals.
²
Then check for secure attachment of the connectors.
²
Mount and fasten the front plate on the device.
Completing Replacement
²
Set the jumpers of the module for operation mode.
²
The device shall recognize the new plug-in module.
²
In case you installed a new module, configure the settings of the new module in PowerSys.
i
i
NOTE
Only qualified electrical engineering personnel is authorized to reset the hardware parameters.
1.7.2
Safety Instructions
1.7 Replacement
20
Smart Communications, PowerLink 100 and PowerLink 50, Product Information
E50405-U53-X-B3-7670, Edition 11.2014
