Siemens POL955, Instructions For Installation, Use And Maintenance Manual

Page: 90 / 96

90 TUTORBIT
COSMOGAS
Continued on the next page
6 - USE
Parameter
Description
Access
level
Adjustment
range
Default value
Custom value
Antistagn hysteresis
Solar pump shutdown hysteresis with respect to “Antistagn On
Temp”
Installer
Value
Value
Antifrost Setpoint
Antifreeze setpoint on the solar panel sensor
. If the sensor falls below this value, the solar pump turns on.
Installer
Value
Value
Antif hysteresis
Solar pump shutdown hysteresis with respect to “Antifrost Setpoint”
Installer
Value
Value
Solar tank sens
Temperature of solar tank sensor
Installer
Value
Value
Solar
Panel T
emp
Solar panel temperature
Installer
Value
Value
DT
control
On or of
f of the solar pump generated by the temperature delta “Solar pump dT
On” and “Solar pump dT
On”
Installer
Value
Value
Antistag. Ctl
State of
Antistagnation function
Installer
Value
Value
Pump
Solar pump state
Installer
Value
Value
Heat Pump state
Installer
HP
Mode
Heat pump setting for as in Configuration>Heat pump> HP
Mode
Installer
Value
Value
State
Heat pump state (Stb = stand-by; Heat = heating; Cool = cooling; DHW= domestic hot water;)
Installer
Value
Value
Autumn condition
If the outdoor temperature is greater than Parameters>Modules>Autumn temp. +1°C, the autumn condition is activated for which cooling does not work
Installer
Active- NonActive
Q1_Pdc
Status of relay Q1 of the HP
control
Installer
On-Of
f
Q2_Pdc
Status of relay Q2 of the HP
control
Installer
On-Of
f
Q3_Pdc
Status of relay Q3 of the HP
control (OFF when it is heating, ON in DHW)
Installer
On-Of
f
Q4_Pdc
N/A
Installer
On-Of
f
Defrost state
State of the defrost
Installer
Active-NonActive
Forced Ignition
Installer
On-Of
f
Increase Cutof
f
Increase cutof
f setpoint to avoid defrost
Installer
Value
Value
Mod 1 Modbus State
Address readings of the modbus module 1. V
isible only if Configuration>System>Modbus Enable=Y
es.
Installer
Comm Error MB 1
N/A
Installer
Value
Value
Unit of measure
N/A
Installer
°C...°F
Type of device
N/A
Installer
Slave...Master
Single-burner condition
N/A
Installer
2 = W
aiting;
9 = In operation; 13 = Fan in post-ventilation; 15 = Pump in post-circulation;
Single-burner state
N/A
Installer
0 = W
aiting;
16 = Heat demand;
Single-burner err code
N/A
Installer
?? = No burner; 255 = No error; See the heat generator
’s manual for any other
codes;
Heating Setp
N/A
Installer
Value
Value
DHW setpoint
N/A
Installer
Value
Value