Siemens HB25D5.2 Series, Instruction Manual

Page: 11 / 24

11
Basic settings
Your appliance has various basic settings, which are preset at
the factory. You can, however, change these basic settings as
required.
If you want to cancel all the changes, you can restore the
factory settings.
1.
If required, press the Ž button to switch off the appliance.
2.
Press and hold the 0 button until ™‚ ‚ appears in the
display.
3.
Press the 0 button until the desired basic setting appears.
4.
Turn the rotary selector to change the basic setting.
5.
Press and hold the
0
button to exit basic settings.
The change is saved.
You can change the following basic settings:
Care and cleaning
In this section, you will find information on
■
the care and cleaning of your appliance
■
Descaling
ã=
Risk of short circuit!
Do not use high-pressure cleaners or steam jet cleaners to
clean your appliance.
Caution!
Risk of surface damage: Do not use
■
harsh or abrasive cleaning agents
■
oven cleaners
■
corrosive or aggressive cleaners, or those containing
chlorine
■
cleaning agents with a high alcohol content
If such an agent comes into contact with the front of the
appliance, wash it off immediately with water.
Caution!
Risk of surface damage: If descaler comes into contact with the
front of the appliance or any other sensitive surfaces, wash it off
immediately with water.
Remove food residues from the cooking compartment as soon
as the appliance has cooled.
Salts are very corrosive and can cause rust. Remove remains
of acidic sauces (ketchup, mustard) or salted food from the
cooking compartment immediately after cooling.
Do not use hard scouring pads or cleaning sponges.
Basic setting Function Possible settings
™‚ ‚
Displays the clock when the appliance is switched off
™‚ ‹
= off
™‚ ‚ = on
™ƒ ‚
Acoustic signal when a button is pressed
™ƒ ‹
= off
™ƒ ‚ = on
™„ ƒ
Length of the acoustic signal at the end of an operation
™„ ‚
= short (30 seconds)
™„ ƒ = medium (2 minutes)
™„ „ = long (10 minutes)
™… ‚
Continue after the door is closed. The operation does not go back to the
beginning when the appliance door is opened
™… ‹ = off
™… ‚ = on
™† ƒ
Water hardness range for the descaling indicator
™† ‹ = softened
™† ‚ = soft (I)
™† ƒ
= medium (II)
™† „
= hard (III)
™† …
= very hard (IV)
™‡ ‚
Acoustic signal for the end of the heating-up time
™‡ ‹
= off
™‡ ‚
= on
™ˆ ‚
Adjust the cooking results in the programmes individually
™ˆ ‚
= cooked normally
™ˆ ƒ
= less thoroughly cooked
™ˆ „ = more thoroughly cooked
™‰ ‹
Restore the appliance to the factory settings:
■
all changes to the basic settings are deleted
■
automatic calibration is carried out again
The appliance is restored to the factory setting if you select ™‰ ‚ and then
press and hold the
4
button for 4 seconds.
™‰ ‹
= do not restore
™‰ ‚ = restore