8. Insert the new battery pack, paying attention to the position of the battery cable
(arrows at 5).
9. Make sure that the holder (4) latches into place correctly.
a
When the battery connector is connected, the internal alarm indicator lights
up red for 5 seconds (flashing pattern number 1 Internal alarm indicator).
a
After a further 10 seconds, the detector signals that it is not installed on the
detector base and the internal alarm indicator flashes green (flashing
pattern number 3).
a
If this does not happen, this means the battery pack is defective and must
not be used.
10. Insert the detector into the detector base.
a
The internal alarm indicator flashes green (flashing pattern number 4) and
the detector is logged on to the radio gateway.
a
If the process of logging on to the radio gateway is successful, the internal
alarm indicator stops flashing.
11. Following the successful logon, replace the battery pack of the next radio
device.
12. Check the status display on the radio gateway or the 'Device localization error'
display on the control panel.
–
If there is a 'Device localization error' message on the radio gateway or the
control panel, the detector will need to be assigned again. Assign the
detector by following the information in Confirming the detector position.
a
The battery pack has now been replaced.
See also
2
Internal alarm indicator [➙ 19]
Maintenance / Repair
Replacing the battery pack
7
A6V10425624_en--_h
43 | 50
Summary of Contents for FDOOT271-O
Page 49: ...A6V10425624_en _h 49 50 ...
