Siemens ECOFAST, Manual

Page: 22 / 77

Installation of Motor Starters
ECOFAST Motor Starters
GWA 4NEB 950 0562-12
2-5
Deutsc
h
Eng
lish
2.3 Setup with motor nearby
2.3.1 Required components
The table below shows which components are required:
Table 2-5: Components required for setting up with the motor nearby
Item Order data Order number
1 Motor starter 3RK1 3..
depending on version
2 4 fixing screws, 5 mm dia., if necessary nuts,
spring washers, plain washers
3 Power cable for motor starter - motor connection
Han 10E
prefabricated
or prepared by customer 3RK1 911-0.. depending
on length, cross section,
Han 10E one end/
both ends
4 Power cable for looping through power
Han Q8 pin / power tee connector
prefabricated
or prepared by customer 3RK1 911-0.. depending
on length and cross
section
Power cable, no looping through of power
Han Q8 at both ends
prefabricated
or prepared by customer 3RK1 911-0.. depending
on length and cross
section
5 AS-i cable, trapezoidal-section yellow,
rubber 2 x 1.5 mm
2
for fieldbus
3RX9 01.-0AA00
depending on length
6 AS-i cable, trapezoidal-section black,
rubber 2 x 1.5 mm
2
for ext. 24 V auxiliary voltage
AUX PWR
3RX9 02.-0AA00
depending on length
7 Cable end covers for sealing open
cable ends (1 set = 10 covers) 3RK1 901-1MN00