Siemens ECOFAST, Manual

Page: 45 / 77

Commissioning and diagnostics
ECOFAST Motor Starters
4-4
GWA 4NEB 950 0562-12
4.2 Commissioning and starting
Software requirements
Table 4-2: Software requirements for commissioning
Requirements for commissioning
Table 4-3: Requirements for commissioning
Testing the wiring from the motor starter to the motor
With the aid of the addressing and diagnostic unit (Order No.: 3RK1 904-
2AB00) you can test the wiring from the motor starter to the motor via the
addressing socket without a PLC by setting the corresponding outputs:
Table 4-4: Testing the wiring from the motor starter to the motor
Further information is provided in the operating instructions for the
addressing and diagnostic unit.
Configuration software
used
Explanations
Configuration software
for the AS–i master used (See AS-i master manual)
Action assumed to have been taken
Further information: see ...
1. Motor starter installed Installation chapter
2. Address set on the motor starter Installation chapter
3. Supply voltage for the motor starter switched on
4. If appropriate, supply voltage for the load switched on
5. Motor starter configured and parameterized
6. Supply voltage for AS-i master switched on
7. AS-i master switched to RUN operating state AS-i master manual
Outputs Control commands (PLC to motor starter)
DO - 0. 0 Motor CW
[1]: ON
[0]: OFF
1 Motor CCW
[1]: ON
[0]: OFF
2 Brake
[1]: ON
[0]: OFF
3 Trip reset
[ 0] –> [1]: ACTIVE
[0], [1]: NOT ACTIVE
0
1