Siemens 7SD502, Instruction Manual

Page: 67 / 178

3$
)NSTALLATION INSTRUCTIONS
6
# ' #
3 9 3 - % ! 3 5 2
6 $ % 7 # / - 0 ! 4 ) " , %
&ORMAT OF MEASURED VALUES FOR THE SYSTEM ,3! INTER
FACE
ONLY DATA IN ACCORDANCE WITH
6$%7 :6%) )%#
DATA IN ACCORDANCE WITH
6$%7 :6%) )%#
EXTENDED BY 3IEMENS SPECIFIED DATA
6 $ % 7 % 8 4 % . $ % $
4HE TRANSMISSION "AUD RATE FOR COMMUNICATION VIA THE
SYSTEM INTERFACE CAN BE ADAPTED TO THE SYSTEM INTER
FACE EG ,3! IF NECESSARY 4HE AVAILABLE POSSIBILITIES
CAN BE DISPLAYED BY REPEATEDLY DEPRESSION OF THE
.O KEY . #ONFIRM THE DESIRED "AUD RATE WITH THE
ENTRY KEY %
3 9 3 " ! 5 $ 2
" ! 5 $
" ! 5 $
" ! 5 $
" ! 5 $
" ! 5 $
3 9 3 0 ! 2 ) 4 9
6 $ % 7 $ ) ' 3 ) 6 , 3 !
0ARITY AND STOP BITS FOR THE SYSTEM ,3! INTERFACE
FORMAT FOR
6$%7 PROTOCOL )%# OR
3IEMENS PROTECTION DATA PROCESSING PROGRAM $)'3)
Q
6 ERSION AND FORMER ,3!
TRANSMISSION WITH ./ PARITY AND 34/0 BITS
TRANSMISSION WITH ./ PARITY AND 34/0 BIT EG FOR
MODEM
. / 3 4 / 0
. / 3 4 / 0
!DDRESS IS RELEVANT ONLY IN CASE THE SYSTEM INTERFACE IS CONNECTED WITH A HARDWARE THAT OPERATES WITH THE
PROTECTION DATA PROCESSING PROGRAM $)'3)
Q
ADDRESS 393 ).4%2& $)'3) 6 4HIS ADDRESS DETER
MINES WHETHER IT SHALL BE PERMITTED TO CHANGE PARAMETERS VIA THIS INTERFACE
3 9 3 0 ! 2 ! - % 4
. /
2EMOTE PARAMETERIZING VIA THE SYSTEM INTERFACE
./ IS NOT PERMITTED
9%3 IS PERMITTED 9 % 3