Installation and operating instructions
AEROMAT VT
Last update: 02.2015
9
Function
Operation by pressure differential: (DS/DSg Type)
•
The room is ventilated as the indoor and outdoor air pressures are equalised (pressure differential). As this happens, the
air normally flows from outside into the room.
•
The air flow into the room varies as the pressure created by the wind changes with the weather.
•
With the optional internal electrical closer, the unit is opened and closed using an external switch.
Ventilator operation (RS Type)
•
The AEROMAT VT RS Type is either equipped with 1 or 2 supply air blowers and/or with 1 or 2 exhaust air blowers.
•
Supply air blower (depending on the the equipment): The outside air is drawn in through the supply air blower and enters
the room as supply air.
•
Exhaust air blower (depending on the equipment): The exhaust air drawn in through the exhaust air blower and makes its
way outside as outgoing air.
•
When the blower is switched off, the AEROMAT VT RS Type functions as a pressure differential ventilator.
Operation
Ventilation without blowers (DS/DSg Type and RS Type)
1. Open sliders
Ventilation with blowers (RS Type)
Note:
Depending on the design, the membrane key is positioned on either the left or right in the AEROMAT VT. If it is on the
right, the membrane key is turned 180° (see figure).
1. Open sliders
2. Set the required blower level using either the membrane key or the external switch
2.
1.
Membrane key
(left)
Membrane key
(right)
Operating with a control cord (optional)
When the slider is operated using control cords, you move the slider into the position you require by alternately pulling on the
two control cords.
Summary of Contents for AEROMAT VT.
Page 2: ......
