6
AEROMAT VT
Installation and operating instructions
Last update: 02.2015
Installation sequence
1. Remove the AEROMAT VT carefully from the packaging and do not place it on the weather grille or front panel. We
recommend storing the unit on a soft surface (e.g. cardboard or sheet) during installation.
2. Close the sliders on the front to prevent dirt (e.g. dust) from entering the unit during installation. If the AEROMAT VT does
not have sliders, tape up the recesses in the front panel with film.
3. If the AEROMAT VT is to be concealed in the window sill, make sure that no dirt and liquids can get inside the weather
grille before the outside window sill is installed.
AEROMAT VT and cover the weather grille with film as shown in illustration.
4. Install the AEROMAT VT in its intended installation position and seal it in accordance with the installation directives
applicable on site.
5. Check AEROMAT VTfor cleanliness prior to starting it up. If necessary, clean the unit thoroughly as described in our
operating and maintenance instructions.
Attention!
Only drill in through-holes for wall plugs and screws in the area indicated (see marker tape).
Important!
Remove any marker tape that is visible after installation.
Interruption of installation work
›
Prior to stopping work or while work is interrupted, protect open ends or areas so that no dust or moisture can enter.
Summary of Contents for AEROMAT VT.
Page 2: ......
