12
AEROMAT VT
Installation and operating instructions
Last update: 02.2015
Replacing the air canal and the filter (optional)
•
The unit’s air canal consists of foam elements. These must be replaced depending on the degree of contamination.
•
Replacement air canals and filters are available from SIEGENIA.
•
Be sure to note the arrangement of the internal parts for special models that do not correspond to the illustration.
•
The AEROMAT VT can only be opened from “room side”.
•
The M5 filters should be replaced if the LED indicator lights up. However, we recommend replacing the filters at least
every 12 months.
•
Important: M5 filters must be replaced not cleaned.
•
The G3 grit filters should be cleaned or replaced if the LED display lights up. However, we recommend replacing the
filters at least every 12 months.
•
Always clean the G3 grit filter manually (e.g. with a vacuum cleaner, wash out using a grease-dissolving cleaning agent).
•
After filter replacement, hold down the membrane key for 5 seconds to reset the LED indicator (filter replacement
indicator).
Membrane key + LED indicator
Function
LEDs do not flash
Membrane key flashes blue
Replace the filters*
*
Only use genuine filters from SIEGENIA. You can purchase replacement filters from SIEGENIA or from specialist retailers.
Removing the front panel
The figure below shows the opening direction for a AEROMAT VT that has been installed horizontally.
1. Open the sliders on the right and left (or in the middle according to design)
2. Pull out the front panel
3. Slide the membrane key out sideways (if present)
4. Remove the front panel and place it on a soft surface (cardboard, sheet)
1.
2.
3.
4.
Summary of Contents for AEROMAT VT.
Page 2: ......
