Figure 75: Hole detection/hole size
•
≥
n hole is greater than or equal to n beams
::
The output becomes active if the configured number of beams or more were
made.
•
≤
n hole is less than or equal to n beams
::
The output becomes active if the configured number of beams or less were made.
•
= n hole is equal to n beams
:
The output becomes active if precisely the configured number of beams were
made.
The hole size that has been set is shown in the
Simulation
area. It can be changed using
the mouse.
Figure 76: Setting the hole size with the mouse
Only take into account consecutive beams:
7
CONFIGURATION WITH SOPAS ET
74
O P E R A T I N G I N S T R U C T I O N S | MLG-2 Pro
8017460.ZIK1/2017-02-13 | SICK
Subject to change without notice