![background image](http://html1.mh-extra.com/html/sick/detem2-core/detem2-core_operating-instructions-manual_1264592031.webp)
Figure 17: Mounting the reinforced stainless steel bracket on a profile frame
Approach
1.
After mounting the reinforced stainless steel bracket, guide the sender/receiver
into it.
2.
Use the two M5 screws to fix the position of the sender/receiver in the reinforced
stainless steel bracket.
5.3.2
Mounting the stainless steel bracket
Overview
With the stainless steel bracket, the sender and receiver can be rotated around their
longitudinal axis.
The sender and receiver are mounted with two stainless steel brackets each.
The stainless steel bracket consists of two parts, which are pushed into each other. The
two parts are connected and the protective device secured with one M5 screw.
An M8 screw with washer is used to mount the stainless steel bracket on a machine or
profile frame.
Important information
NOTE
When mounting the stainless steel bracket, the M8 screw can present a risk of injury if
it is too long. Select an appropriate screw length to prevent any risk of injury from an
overrun.
Mounting the stainless steel bracket on a machine or profile frame
Table 4: Mounting the stainless steel bracket on the side and back
Mounting
method
Description
On the side
With the M8 screw through the stainless steel bracket to the machine or
profile frame. A screw nut or threaded hole is required on the machine or
profile frame.
On the back
With the M8 screw through the stainless steel bracket to the machine or
profile frame. A screw nut or threaded hole is required on the machine or
profile frame.
MOUNTING
5
8021554/14Q7/2020-04-27 | SICK
O P E R A T I N G I N S T R U C T I O N S | deTem2 Core IP69K
31
Subject to change without notice