User levels
Password
User/Authorizations
Service
servicelevel
Service staff: Make advanced config‐
uration settings
7.4
Scan view & live information
Every menu page shows the scan view of the device and (after the background is taught
in) the current status information.
Figure 11: Scan view and live information
Scan view
The detection area of the device is visualized in the scan view. The device is situated in
the center of the coordinate system with distance information in meters. The gray area
is the sensor blind spot.
A taught-in background is marked with black measurement points.
Measurement points which do not correspond to a taught-in background are merged
into measurement point groups (= clusters) and also shown as green points. Depending
on the selected object parameters (
see "Advanced settings", page 30
), a person is
identified and surrounded by a blue circle whose diameter corresponds to the minimum
distance to be observed. If two circles intersect, the minimum distance has been
undercut.
Live information
The live information shows the current distance in mm between the two people who are
currently the closest to one another. If the permissible minimum distance is undercut,
the color of the status display changes from green to red.
The number of currently detected people is also displayed. If the permissible maximum
distance is exceeded, the color of the status display changes from green to red.
If no people or only one person is detected, the current distance is output as 0, but
undercutting is not signaled.
7.5
Start
The start menu is called up after the IP address of the device is entered in the address
line of the web browser.
The scan view is shown on the left-hand side. The raw measurement data is initially dis‐
played there for device alignment.
7
OPERATION
28
O P E R A T I N G I N S T R U C T I O N S | TiM8xx DistanceGuard
8025963//2020-08-05 | SICK
Subject to change without notice
