SIATA Aqua Timer Plus, Use And Maintenance Manual

Page: 6 / 34

Aqua Timer Plus
- 6/34
3 –LEDS AND KEYS MEANING
The tabs. 1 and 2 describe the meaning respectively of the LEDs and of the keys on the front panel of the controller, and
which can be seen in fig. 1.
Tab. 1 – Functionality of the LEDs
LED Meaning
A SERVICE On when column A is in service
B SERVICE On when column B is in service
WAIT. REGEN. The controller waits until the programmed time for the regen.
ALARM Alarm
TIME Control of the time for the start of the regeneration
VOLUME Control of the volume for the start of the regeneration
DUPLEX Duplex distributor in use
SALT Alarm when salt has run out
TIME+VOLUME Both the LEDs on, mixed control time/volume for the regen.
Tab. 2 – Functionality of the keys
Key Description
CODE
Access to the programming of the work parameters through the protection code.
During the programming, returns to zero the value being modified
RESET
Allows for the programming to be outleted from, without memorising the last value keyed in.
Pressed during the service, resets the counters of the management of salt alarm.
PROGRAM
MODE
Allows access to the programming functions.
REGENER.
Starts up the regeneration.
Pressed during the stop time, returns to zero the residual time and starts up the next phase.
ADVANCE
Changes the visualisation mode of the display.
In programming, increases the value being modified.
TIME OF
DAY
Resetting of the local time.
If the flag 1HL is programmed to 1, after the time the day of the week is set.