- 68 -
@
Set Supervisor/User Password
Steps to set supervisor/user password are described as follows:
New Password Setting:
1. While pressing <Enter> to set a password, a dialog box appears to
ask you enter a password.
2. Key in a new password that can not exceed eight characters.
3. System will request you to confirm the new password again.
4. When completed, new code takes effect.
No Password Setting:
If you want to disable the password, just press <Enter> as a password
input is requested.
If You Forget Password:
If you forget the password, the only way to access the system is to clear
the CMOS memory. Please refer to page 25 on clear CMOS setting.
@
Save & Exit Setup
Pressing <Enter> on this item asks for confirmation: SAVE to CMOS
and EXIT (Y/N) ? Y
Pressing 'Y' stores the selections made in the menus of CMOS. Next
time you boot your computer, the BIOS configures your system accord-
ing to the Setup selections stored in CMOS. After saving the values, the
system is restarted again.
@
Exit Without Saving
Pressing <Enter> on this item asks for confirmation: Quit Without
Saving (Y/N) ? N
This allows you to exit from Setup without storing in CMOS any
change. The previous selections remain in effect. This exits from the
Setup utility and restarts your computer.
