- 68 -
HDD Power Down (Disabled)
HDD Power Down (Disabled)
HDD Power Down (Disabled)
HDD Power Down (Disabled)
HDD Power Down (Disabled)
When this item enabled and after the set up time of system inactivity,
the hard disk drive will be powered down while all other devices
remain active.
"
The choice: Disabled or 1 Min~15 Min.
HDD off When Suspend (Disabled)
HDD off When Suspend (Disabled)
HDD off When Suspend (Disabled)
HDD off When Suspend (Disabled)
HDD off When Suspend (Disabled)
The choice is disabled/enabled.
"
The choice: Disabled or Enabled.
Soft-Off by PWR-BTTN (Instant-Off)
Soft-Off by PWR-BTTN (Instant-Off)
Soft-Off by PWR-BTTN (Instant-Off)
Soft-Off by PWR-BTTN (Instant-Off)
Soft-Off by PWR-BTTN (Instant-Off)
Under ACPI you can create a software power down. In a software
power down, the system can be resumed by Wake UP Alarms. This
item lets you install a software power down that is controlled by the
power button on your system. If the item is set to Instant-Off, then the
power button causes a software power down. If the item is set to Delay4
Sec. then you have to hold the power button down for 4 seconds to
cause a software power down.
"
The choice: Instant-Off or Delay 4 Sec.
CPU Thrm-Throttling (50.0%)
CPU Thrm-Throttling (50.0%)
CPU Thrm-Throttling (50.0%)
CPU Thrm-Throttling (50.0%)
CPU Thrm-Throttling (50.0%)
Use this item to specify the CPU speed ( at percentage ) to slow down
the CPU when it reaches the predetermined overheat temperature.
"
The choice: 87.5%, 75.0%, 62.5%,50.0%,37.5%, 25.0%, or 12.5%.
Wake-Up by PCI card (Enabled)
Wake-Up by PCI card (Enabled)
Wake-Up by PCI card (Enabled)
Wake-Up by PCI card (Enabled)
Wake-Up by PCI card (Enabled)
This item Enabled/Disabled PCI card wake up for PCI Spec 2.2.
"
The choice: Enabled or Disabled.
Wake on by Ring (Disabled)
Wake on by Ring (Disabled)
Wake on by Ring (Disabled)
Wake on by Ring (Disabled)
Wake on by Ring (Disabled)
If this item is enable, it allows the system to resume from a software
power down or power-saving mode whenever there is an incoming call
to an installed fax/modem. You have to connect the fax/modem to the
mainboard.
"
The choice: Enabled or Disabled.
Wake Up On LAN (Disabled)
Wake Up On LAN (Disabled)
Wake Up On LAN (Disabled)
Wake Up On LAN (Disabled)
Wake Up On LAN (Disabled)
If this item sets to Enable, the system power will be turned on when the
LAN port receives an incoming signal. You have to connect the fax/
modem to the mainboard Wake On LAN connector for this feature to
work.
"
The choice: Enabled or Disabled.
