- 19 -
On Board Audio Controller Setting - JP6
Figure 2-27
Hardware Reset Connector - RST
Attach 2-pin hardware reset switch to it. Closing the reset switch restarts the system.
PW-LED Connector - PW LED
Power LED connector is a 3-pin connector for attached to the case's Power LED.
EPMI Connector - EPMI
Hardware System Management Interface connector may attach a 2-pin momentary switch to it.
When push it will force system get into power saving mode, and the system will resume when
switch is pushed again.
GLED Connector - GREEN LED
Attach a 2-pin Green LED cable to it. The Green LED lights when the system get intopower saving
mode.
Figure 2-28
HOT-679V mainboard provides on-board PnP 64
voices wavetable sound chip which based on Creative
ES1371 AC97 PnP 3D integrated audio controller chip.
Jumper JP6 is used to enabled or disabled it.
On-board Audio Controller
Disabled
On-board Audio Controller
Enabled
Front Panel Connectors (JP10)
Speaker Connector - SPEAKER
PC speaker connector may attach a 4-pin PC speaker
cable from the case to this connector.
HDD LED Connector - IDE LED
Attach a 2-pin IDE drive LED cable to this connector.
The LED lights when an IDE device is active.
ATX Power On/Off Switch Connector
- PW ON
Attach a 2-pin momentary type switch to this connector
for turning on or off your ATX power supply.
Connectors
