- 42 -
Primary Master / Slave UDMA
On this mainboard, VIA Chipset improves IDE transfer rate using Bus Master UltraDMA/
33 IDE which can handle data transfer up to 33MB/sec. The options are
Disabled,
Enabled and Auto, Auto
is the default settings for on board Primary Master / Slave
UltraDMA33
.
Note : Your hard drive must also support UDMA for this feature to work.
Secondary Master / Slave UDMA
On this mainboard, VIA Chipset improves IDE transfer rate using Bus Master UltraDMA/
33 IDE which can handle data transfer up to 33MB/sec. The options are
Disabled,
Enabled and Auto, Auto
is the default settings for on board Secondary Master/Slave
UltraDMA33
.
Note : Your hard drive must also support UDMA for this feature to work.
Init Display First
This item is used to determine initial device when system power on. The options are
PCI
and
AGP
.
POWER ON Function
This item
is used to defined Keyboard & PS/2 mouse power-on function enabled or
disabled. The options are
Button Only
,
Keyboard 98, Password, HOT-Key, Mouse
Left
and
Mouse Right
.
Note:1. When item of PS/2 Mouse or HOT-Key is selected, please also adjust jumper
JP1 to the proper position.
2. USB keyboard, USB Mouse and Serial Mouse are not supported to this
function.
KB Power ON Password
This item set the keyboard power-on password. When using keyboard to power on, just
Enter the password.
Hot Key Power ON
Power-on by soft-on/off button and keyboard are available.
KBC Input Clock
This item to set the input clock to onboard keyboard controller. The options are
8MHz
and
12MHz
.
Onboard FDC Controller
This item specifies onboard floppy disk drive controller. This setting allows you to
connect your floppy disk drives to the onboard floppy connector. Choose the "
Disabled
"
settings if you have a separate control card.
