- 19 -
On Board Audio Controller Setting - JP12
HOT-675Z mainboard provides on-board PnP 64
voices wavetable sound chip which based on Creative
ES1373 AC97 PnP 3D integrated audio controller chip.
Jumper JP12 is used to enabled or disabled it.
On-board Audio Controller
Disabled
On-board Audio Controller
Enabled
Front Panel Connectors
ATX Power On/Off Switch Connector
- S2
Attach a 2-pin momentary type switch to this connector
for turning on or off your ATX power supply.
HDD LED Connector - S3
Attach a 2-pin IDE drive LED cable to this connector.
The LED lights when an IDE device is active.
Hardware Reset Connector - J15
Attach 2-pin hardware reset switch to it. Closing the
reset switch restarts the system.
Speaker Connector - JP6
PC speaker connector may attach a 4-pin PC speaker
cable from the case to this connector.
Connectors
Figure 2-27
EPMI Connector - JP11(1-2)
Hardware System Management Interface connector may attach a 2-pin momentary switch to it. When
push it will force system get into power saving mode, and the system will resume when switch is
pushed again.
GLED Connector - JP11(3-4)
Attach a 2-pin Green LED cable to it. The Green LED lights when the system get intopower saving
mode.
POWER LED Connector - JP9
Power LED connector is a 3-pin connector for attached to the case's Power LED. Pin 1 and 3 are for
power LED and pin 2 is empty.
Figure 2-26
