18
Connectors
Front Panel Connectors (JP6)
Hardware Reset Connector - RST
Attach 2-pin hardware reset switch to it. Closing the
reset switch restarts the system.
KeyLock Connector
- PW-LED Key-Lock
KeyLock & Power LED connector is a 5-pin connector
for a lock that may be installed on the system case for
enabling or disabling the keyboard. It also attached to
the case's Power LED. Pin 1 and 3 are for power LED
and pin 4 and 5 are for keylock, pin 2 is useless.
Speaker Connector - Speaker
PC speaker connector may attach a 4-pin PC speaker
cable from the case to this connector.
SMI Connector - SMI
Hardware System Management Interface connector may attach a 2-pin momentary switch to it.
When push it will force system get into power saving mode, and the system will resume when
switch is pushed again.
GLED Connector - GLED
Attach a 2-pin Green LED cable to it. The Green LED lights when the system get into power
saving mode. The Green LED off when the system resume back to normal mode.
HD LED Connector - IDE
Attach a 2-pin IDE drive LED cable to this connector. The LED lights when an IDE device is
active.
ATX Power On/Off Switch Connector - PWR_BT
Attach a 2-pin momentary type switch to this connector for turning on or off your ATX power
supply.
Figure 2-8: Front Panel Con-
nector location
