17
Power Supply Type Jumper - JP8
CMOS Clear - JP2
HOT-591P mainboard supports jumper JP2 for
discharging mainboard’s CMOS memory.
This jumper can clear the CMOS data stored
in the subsystem chip. To clear the CMOS data
please follow listed steps:
1) Turn off the PC,
2) Remove the jumper cap from JP2 pin 1-2,
3) Insert the jumper cap to JP2 pin 2-3
for a brief while,
4) Remove the jumper cap from JP2 pin 2-3,
5) Reinsert the jumper cap to JP2 pin 1-2,
6) Turn on the PC.
Figure 2-7: Clear CMOS
Jumper JP2 location
Due to different designs, there are two Power Supply Type : 12-pin AT Power Supply and
20-pin ATX Power Supply. HOT-591P support both type of Power Supply. Select the
correct type according to the Power Supply you are using.
JP8
AT/ATX Power Selection
12-Pin AT Power Supply
20-Pin ATX Power Supply
Flash EEPROM Vpp - JP5
HOT-591P mainboard supports two types of
Flash EEPROM:
5 volt and 12 volt. By setting up jumper JP5,
the main board can use both 5V or 12V flash
EEPROM with new system BIOS files as they
come available.
JP5 Pin 2-3 Close for 12V Flash EEPROM
JP5 Pin 1-2 Close for 5V Flash EEPROM
Figure 2-5: JP8 AT/ATX Power Jumper location
Table 2-11
Figure 2-6: Flash Type Jumper
JP5 location
