43
Software
All preferences apply to each device in the Configuration.
① Switch Behavior
Customize the switch on each transmitter type.
•
Toggle (default):
Press and release the button to change the status
to Active or Mute.
•
Push-to-talk:
Hold button to pass audio.
•
Push-to-mute:
Hold button to mute the audio.
•
Disabled:
The button does not affect the audio.
② Initial State from Charger
Assigns the state for the transmitter after it has been removed from the
charger:
•
Active:
On and passing audio to the network.
•
Mute:
On but the audio is muted.
•
Standby:
On but in a 'sleep' state with audio muted. Standby
conserves battery charge and enables a change to the transmitter's
status from the control software.
•
Off:
Power is off. A transmitter in this state cannot be remotely
controlled by the software.
③ LED Behavior
Set the behavior of the mute/active LED for each transmitter type.
Standby mode is always represented with a pulsing red LED.
Active
Mute
Solid Green*
Solid Red
Solid Red
Flashing Red
Solid Red
Off
External LED Control
*Not available for MX400R series gooseneck microphones
④ Mute Preference
•
Local Mute - Individual (default):
Each transmitter is muted
individually.
•
Local Mute - All:
All transmitters mute when any transmitter is muted.
•
External Mute:
Transmitter audio is on, and muted from a 3rd-party
controller.
Preferences Tab
⑤ RF Power
Determines the RF coverage of an access point.
•
Low:
25 ft (1mW)
•
Medium:
50 ft (3 mW)
•
Medium High:
100 ft (16 mW)
•
Max:
150 ft (80 mW)
⑥ Out of Range Alarm
When enabled, a transmitter will audibly beep when it is taken out of
the RF coverage area. (Disabled by default.)
⑦ Back in Range Action
Transmitters can be set to automatically activate (default) or mute when
they re-enter the RF coverage area.
⑧ Standby Mode
• Local (default): Transmitter can individually be activated.
• Global: All transmitters are activated at the same time from Standby
mode.
⑨ Linking Preference
The Link procedure can be restricted to the control software by
disabling the hardware Link button on the Networked Charging Station.
By default, the Link button is enabled.
⑩ Language
Determines the language of the control software.
⑪ Password Setup
The default password for the device is 'admin'. The following describes
access rights for each logon:
Admin (default):
Full monitoring and editing access. The Admin can
enable or disable the Tech- and Guest-level logon.
Tech:
Monitoring with limited editing access.
Guest:
Monitoring only.
⑫ Save/Load Preferences
Saves the preferences of the Configuration as a file to the computer.
The file can be loaded and will overwrite the settings for all devices in
the Configuration.
⑬ Register the Product Link
Links to Shure website for product registration.
①
②
④
⑤
③
⑩
⑪
⑥
⑦
⑧
⑨
⑫
⑬