![background image](http://html1.mh-extra.com/html/shure/mxw-series/mxw-series_user-manual_1261303058.webp)
58
Microflex Wireless Specifications
Safety Information
MXW1
Bodypack Microphone Transmitters:
These transmitters have been tested and found to comply with
international radiation exposure limits set forth for an uncontrolled
environment. This equipment is in direct contact with the body of the user
under normal operating conditions. These transmitters must not be co-
located or operating in conjunction with any other antenna or transmitter.
MXW2, MXW6, MXW8, MXWAPT4, MXWAPT8
Hanheld Microphone Transmitters, Tabletop Boundary Microphone
Transmitters, Tabletop Gooseneck Microphone Transmitters, Wireless
Access Point Transmitters:
These mobile transmitters are intended for use at distances greater than
20 centimeters from the human body. These mobile transmitters are
exempt from the testing requirements of international radiation exposure
standards due to their proximity to the body of the user in their intended
use case and their low power output. These mobile transmitters shall be
placed or installed at least 20 cm from any person and must not be co-
located or operating in conjunction with any other antenna or transmitter.
Important Product Information
The equipment is intended to be used in professional audio applications.
EMC conformance testing is based on the use of supplied and
recommended cable types. The use of other cable types may degrade
EMC performance.
Changes or modifications not expressly approved by Shure
Incorporated could void the FCC authorization to operate this
equipment.
Please follow your regional recycling scheme for batteries, packaging, and
electronic waste.
Note:
This device is not intended to be connected directly to a public
internet network.
Information to the user
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Certifications
This device complies with Part 15 of the FCC Rules and with Industry
Canada licence-exempt RSS standard(s). Operation of this device is subject
to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference
that may cause undesired operation of the device. Le présent appareil
est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur
de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Conforms to electrical safety requirements based on IEC 60065.
This product meets the Essential Requirements of all relevant European
directives and is eligible for CE marking.
The CE Declaration of Conformity can be obtained from Shure Incorporated
or any of its European representatives. For contact information please visit
www.shure.com
The CE Declaration of Conformity can be obtained from: www.shure.com/
europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: 49-7262-92 49 0
Fax: 49-7262-92 49 11 4
Email: [email protected]
MXWNCS4, MXWNCS8
Authorized under the FCC verification provision per Part 15b.
This Class B digital apparatus complies with Canadian ICES-003. Cet
appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.
Note:
See the label located on the bottom side of the charger enclosure
for the FCC marking, the CE marking, the C-Tick marking, and the
electrical ratings.
MXW1, MXW2, MXW6, MXW8, MXWAPT4, MXWAPT8
Certified under FCC Part 15.
FCC:
DD4MXW1, DD4MXW2, DD4MXW6, DD4MXW8, DD4MXWAPT4,
DD4MXWAPT8.
Meets applicable requirements of RSS-213.
IC:
616A-MXW1, 616A-MXW2, 616A-MXW6, 616A-MXW8,
616A-MXWAPT4, 616A-MXWAPT8.
Trademarks
Audinate®, the Audinate logo and Dante are trademarks of Audinate Pty Ltd.