9
Ordercode: 50794
Truss Booster RDM 1-6
Back
Fig. 03
14)
6 x 5-pin DMX/RDM signal connector OUT
Installation
Remove all packing materials from the Truss Booster RDM 1-6. Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Setup and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
Summary of Contents for Truss Booster RDM 1-6
Page 16: ...2019 Showtec...
