8
Ordercode: 30774
Stage Blinder 8 DMX
Installing the Lamp
The Stage Blinder 8 DMX uses the Par 36 G53 Screw MFL GE 120V/650W (DWE) bulb (ordercode
) or
the Showtec Par 36 120V/650W (DWE) bulb (ordercode
), as manufactured by all popular
manufacturers. Use only the appropriate lamp for your unit.
Note that, product versions that use other lamps, may be offered in the future. Check your product
specification label for information.
Always disconnect from electric mains power supply before changing lamps.
The lamp has to be replaced when it is damaged or deformed due to the heat.
Do not install lamps with higher wattage
! Lamps with higher wattage generate temperatures the device
was not designed for.
Damages caused by non-observance are not subject to warranty.
Procedure
01)
Loosen the 2 screws on the front of the lamp housing.
02)
Gently remove the metal lamp housing.
03)
Read lamp instructions. Do not touch the lamp bulb glass. Gently remove the lamp from its socket.
04)
Unscrew the 2 wires on the back of the lamp and remove the lamp. Oil on hands shortens the lamp
life. (If you touch the bulb glass, wipe off the glass with a clean, lint-free towel and rubbing alcohol.).
05)
Take the new lamp out of the box.
06)
Take the 2 cables and tighten the screws on the back of the lamp. Place the lamp in the socket.
07)
Put the metal lamp housing back and fasten the 2 screws snugly.
Fig. 04
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
