SHOWTEC Spider LED, User Manual

Page: 16 / 20

14
Channel 5 – LED movement 2 (Only works when CH1 is set between 50-199 )
0-255 Left to right from slow to fast
Channel 6 – LED movement 3 (Only works when CH1 is set between 50-199 )
0-255 Inside to outside from slow to fast
Channel 7 – LED movement 4 (Only works when CH1 is set between 50-199 )
0-255 Up to down, left to right, inside to outside from slow to fast
Channel 8 – Strobe
0-255 Strobe from slow to fast
Channel 9 – Dimmer (Only works when CH1 is set between
15
-
99
)
0-14 Full On
15-255 Dimmer intensity from black to brightest
Channel 10 – Lens Selection (Only works when CH1 is set between
15
-
99
)
0-63 5 lenses illuminated
64-127 4 lenses illuminated
128-190 3 lenses illuminated
191-255 2 lenses illuminated
Maintenance
The Showtec Spider LED requires almost no maintenance. However, you should keep the unit clean.
Otherwise, the fixture’s light-output will be significantly reduced. Disconnect the mains power supply, and
then wipe the cover with a damp cloth. Do not immerse in liquid. Wipe lens clean with glass cleaner and
a soft cloth. Do not use alcohol or solvents. Keep connections clean. Disconnect electric power, and
then wipe the connections with a damp cloth. Make sure connections are thoroughly dry before linking
equipment or supplying electric power.
The operator has to make sure that safety-relating and machine-technical installations are to be
inspected by an expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are to be
inspected by a skilled person once a year.
The following points have to be considered during the inspection:
1. All screws used for installing the device or parts of the device have to be tightly connected and must
not be corroded.
2. There may not be any deformations on housings, fixations and installation spots.
3. Mechanically moving parts like axles, eyes and others may not show any traces of wearing.
4. The electric power supply cables must not show any damages or material fatigue.
Replacing a Fuse
Power surges, short-circuit or inappropriate electrical power supply may cause a fuse to burn out. If the
fuse burns out, the product will not function whatsoever. If this happens,
follow the directions below to do
so.
1. Unplug the unit from electric power source .
2. Insert a screwdriver into the slot in the fuse cover. Gently pry up the fuse cover. The fuse will come out .
3. Remove the used fuse. If brown or unclear, it is burned out .
4. Insert the replacement fuse into the holder where the old fuse was. Reinsert the fuse cover. Be sure to
use a fuse of the same type and specification. See the product specification label for details.