7
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Remove all packing materials from the Spider LED. Check that all foam and plastic padding is removed.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Control Modes
There are 4 modes:
• Auto Run Programs
• Sound-controlled
• Master/Slave
• DMX512
One Spider LED (
Auto Run Programs
)
1.
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
Plug the end of the electric mains power cord into a proper electric power supply socket.
3.
When the Spider LED is not connected by a DMX-cable, it functions as a stand-alone device.
Dipswitch #10 must always be set to OFF for custom control
You can set dipswitch #1, #2, #3, #4, #5, #7, #8 or #9 to your desired operating mode.
Single LED move from left to right and up to down
Single row LED move from up to down
Single row LED move from left to right
LED move from up to down and lift to right
LED flash and move from up to down and lift to right
LED1.2.3.4 eye light bounce-Slow
LED1.2.3.4 eye light bounce-Medium
LED1.2.3.4 eye light bounce-Fast
Strobe
Summary of Contents for Spider LED
Page 14: ...12 DMX Quick Reference Chart...
Page 20: ......
