SHOWTEC spectral 260 white, User Manual

Page: 8 / 24

7
Ordercode: 43518
Spectral 260 White
Backside
Fig. 02
04) Schuko Powercable
05) DMX DIP Switches
06) Safety Eye
07) Special DMX-IN/ DMX-OUT cable
Installation
Remove all packing materials from the Spectral 260 White.
Check that all foam and plastic padding is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
Control Modes
There are 4 modes: Auto (Built-in programs)
Static Colors (manual)
Master/Slave
DMX512 (2, 2, 3 or 5 Channels)
One Spectral Auto (Built-in programs)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Use the safety cable which is included.
03) When the Spectral is not connected by a DMX-cable, it functions as a stand-alone device.
Dipswitch #12 must always be set to ON for Automatic control.
04) Use dipswitch 1-4 to set one of the 12 programs.
Program / No function Dipswitches ON:
No function #1, #2, #3, #4 and #12
Program 1 (static) #1, #2, #3 and #12
Program 2 (static) #1, #2, #4 and #12
Program 3 (fast fade in to slow fade out) #1, #2 and #12