SHOWTEC showdesigner 512, User Manual

Page: 5 / 19

3
 Avoid flames and do not put close to flammable liquids or gases.
 Always disconnect power from the mains, when device is not used or before cleaning! Only
handle the power-cord by the plug. Never pull out the plug by tugging the power-cord.
 Make sure that the device is not exposed to extreme heat, moisture or dust.
 Make sure that the available voltage is not higher than stated on the rear panel.
 Make sure that the power-cord is never crimped or damaged. Check the device and the power-
cord from time to time.
 If device is dropped or struck, disconnect mains power supply immediately. Have a qualified
engineer inspect for safety before operating.
 If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do
not switch it on immediately. The arising condensation water might damage your device. Leave
the device switched off until it has reached room temperature.
 If your Showtec device fails to work properly, discontinue use immediately. Pack the unit securely
(preferably in the original packing material), and return it to your Showtec dealer for service.
 Repairs, servicing and electric connection must be carried out only by Showtec.
 For replacement use fuses of same type and rating only.
 This device falls under protection class I. Therefore it is essential to connect the yellow/green
conductor to earth.
 WARRANTY: Till one year after date of purchase.
OPERATING DETERMINATIONS
This device is not designed for permanent operation. Consistent operation breaks will ensure that the
device will serve you for a long time without defects.
If this device is operated in any other way, than the one described in this manual, the product may suffer
damages and the
warranty becomes void.
Any other operation may lead to dangers like short-circuit, burns, electric shock, lamp explosion, crash
etc.
You endanger your own safety and the safety of others!
Improper installation can cause serious damage to people and property !
Connect the device to the mains with the power-plug.
Always pay attention, that the right color cable is connected to the right place.
International EU (including UK)
From April 2004
North America Pin
L Brown Black Phase
N Blue White Neutral
Green/Yellow Green Protective Earth
Make sure that the device is always connected properly to earth!