SHOWTEC showdesigner 512, User Manual

Page: 11 / 19

9
5. Jog Wheels
5.1 X/Speed, Y/Slope:
Use to control the pan/ tilt of the fixtures (the pan/ tilt
channels should be assigned to the jog wheels) and
speed/ slope adjustment of chase and chase group.
6. Master control
6.1 Master control buttons
The master control buttons Dimmer 1, Dimmer 2, Dimmer 3
are respectively used to enable/disable and setup the
three master controls.
6.2 Master faders
Master faders Master 1 , Master 2 , Master 3 are used to
control the maximum output value of the assigned channels.
They only work when
Dimmer 1 , Dimmer 2 , Dimmer 3 are
enabled (LED indicator on).
Controller Backside
Fig. 2
7. DMX Out 1:
This connector sends your DMX value to the DMX fixture or DMX pack.
8. DMX Out 2: This connector sends your DMX value to the DMX fixture or DMX pack.
9. Data: Data port .
10. Microphone .
11. Audio Input: This jack accepts a line level audio input signal ranged from 100 mV to 1Vpp.
12. MIDI In: Not activated in the current software version.
13. MIDI Thru: Not activated in the current software version.
14. Main Fuse: T1,5A/250V.
15. Power: On/ Off.
16. IEC Connector