SHOWTEC Performer 2000 RGBAL, Manual

Page: 10 / 40

9
Ordercode: 33038
Performer 2000 RGBAL
Backside
Fig. 02
05)
100-240V Pro power connector Blue IN
06) 3-pin DMX signal connector IN
07) 5-pin DMX signal connector IN
08) 3-pin DMX signal connector OUT
09) 5-pin DMX signal connector OUT
10) 100-240V Pro power connector Gray OUT
11) Fuse T6,3AL/250V
12) LCD d control buttons
Installation
Remove all packing materials from the Performer 2000 RGBAL. Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.