16
Ordercode: 43740
Helix M1000 Q4 Mobile
Multiple Helixes (Wireless DMX Control)
You can use the Helix in a wireless DMX setup. Make sure the device is operating in wireless DMX mode,
which can be set in the main menu (see page 25 for more information).
Sweden 2.4GHz Wireless Communication Module
Communication distance:
depending on the transmitting power or transmitter module
Test conditions:
W-DMX TRx Transmitter module, 2dBi Antenna, transmitting power
20dBm (100mW)
Range indoor:
60 m (approx. through three concrete walls)
Range outdoor:
250 m
Wireless DMX Connection
The wireless receiving module “Nano G5 Receiver, 2.4GHz”, provided by Swedish WIRELESS SOLUTION,
only has a 2.4 GHz wireless signal receiving function. In order to establish a wireless connection, please
use the (
) W-DMX MicroBox F-1 G5 Transceiver by WIRELESS SOLUTION. To control the status of the
wireless communication, please look at the green LED indicator light on the right-hand side of the display.
Note: When the Helix receives a wireless DMX signal, then this signal will also be present at its 5-pin DMX
output (05). However, the Helix has not been designed to send wireless signals. Therefore, always
connect the Helix devices to each other using a DMX cable.
Wireless DMX Problems
01)
No signal from the W-DMX transmitter.
The LED indicator will blink quickly.
02)
Proper connection with the W-DMX transmitter, but no DMX signal is present.
The LED indicator will blink slowly.
When the wireless DMX communication is unhindered and a DMX signal is present, the LED indicator will
always be on.
The Helix M1000 Q4 Mobile cannot receive a W-DMX signal
and a DMX cable signal at the same time
When the device is in Auto mode or Built-in Programs mode, please ensure that the paired 2.4GHz
wireless signal transmitter is OFF.
The Helix M1000 Q4 Mobile is only a W-DMX receiver and never
a W-DMX transmitter
Connect the Helix to the Wireless DMX Signal Transmitter
The Helix cannot actively match a random wireless signal transmitter.
In order to create a wireless match, please check the manual of your wireless signal transmitter.
We advise you to use the W-DMX MicroBox F-1 G5 Transceiver (
) by WIRELESS SOLUTION (Fig. 12).
Fig. 12
Disconnect the Helix from the Wireless DMX Signal Transmitter
01)
Turn off/unlink the W-DMX. In order to do so, deactivate W-DMX (see page 25 for more information).
02)
Unlink the Helix (see page 25 for more information).
03)
The Helix will now be disconnected.
