13
Ordercode: 43740
Helix M1000 Q4 Mobile
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Control Modes
There are 6 modes:
●
Auto
●
Built-in Programs
●
Manual
●
Master/Slave
●
DMX-512 (4CH, 6CH, 10CH)
●
Wireless DMX control
One Helix (Auto, Built-in Programs)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Always use a safety cable (ordercode 70140 / 70141).
03)
Plug the end of the electric mains power cord into a proper electric power supply socket.
04)
For the light output to be visible, press the power switch ON/OFF (08). The current from the built-in
battery is responsible for the light output. The True1 pro power cable should be used only when
charging the battery.
05)
When the Helix is not connected with a DMX cable, it functions as a stand-alone device.
06)
Please see pages 26–27 for more information about Auto and Built-in programs.
One Helix (Manual Mode)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Always use a safety cable (ordercode 70140 / 70141).
03)
Plug the end of the electric mains power cord into a proper electric power supply socket.
04)
For the light output to be visible, press the power switch ON/OFF (08). The current from the built-in
battery is responsible for the light output. The True1 pro power cable should be used only when
charging the battery.
05)
When the Helix is not connected with a DMX cable, it functions as a stand-alone device.
06)
Please see page 26 for more information about Manual mode.
