12
Ordercode: 51332
Galactic G300
Control Modes
There are 4 modes:
•
Autoshow 1 Autoshow 2
•
Musicshow 1 + Musicshow 2
•
Master/Slave
•
DMX-512 (13CH)
One Galactic (Autoshow 1+2)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Always use a safety cable (ordercode 70140 / 70141).
03)
Plug the end of the electric mains power cord into a proper electric power supply socket.
04)
When the Galactic is not connected by a DMX-cable, it functions as a stand-alone device.
05)
Please see page 14 for more information about the Autoshow effects.
One Galactic (Sound-controlled Musicshow 1+2)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Always use a safety cable (ordercode 70140 / 70141).
03)
Plug the end of the electric mains power cord into a proper electric power supply socket.
04)
When the Galactic is not connected with a DMX-cable, it functions as a stand-alone device.
05)
Please see page 14 for more information about the Sound-controlled mode.
Multiple Galactics (Master/Slave Mode)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Always use a safety cable (ordercode 70140 / 70141).
03)
Plug the end of the electric mains power cord into a proper electric power supply socket.
04)
Use a 3-pin XLR cable to connect the Galactics.
The pins:
01)
Earth
02)
Signal (-)
03)
Signal (+)
05)
Link the units as shown in Fig. 03, connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units. You can
use the same functions on the master device as described on page 18 (Built-in or Sound-controlled).
This means on the master device you can set your desired operation mode and all slave devices will
react the same as the master device.
Multiple Galactics Master/Slave Set Up
Fig. 03
