4
Ordercode: 51332
Galactic G300
•
Always check and position the laser before anybody enters the room, when the laser is facing an
area with people.
•
Always keep case closed while operating.
•
Always allow free air space of at least 50 cm around the unit for ventilation.
•
Always disconnect power from the mains, when device is not used or before cleaning! Only handle
the power cord by the plug. Never pull out the plug by tugging the power cord.
•
Make sure that the device is not exposed to extreme heat, moisture or dust.
•
Make sure that the available voltage is not higher than stated on the rear panel.
•
Make sure that the power cord is never crimped or damaged. Check the device and the power
cord from time to time.
•
If the external cable is damaged, it has to be replaced by a qualified technician.
•
If the lens is obviously damaged, it has to be replaced. So that its functions are not impaired, due to
cracks or deep scratches.
•
If device is dropped or struck, disconnect mains power supply immediately. Have a qualified
engineer inspect for safety before operating.
•
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not
switch it on immediately. The arising condensation water might damage your device. Leave the
device switched off until it has reached room temperature.
•
If your Showtec device fails to work properly, discontinue use immediately. Pack the unit securely
(preferably in the original packing material), and return it to your Showtec dealer for service.
•
For adult use only. Device must be installed out of the reach of children. Never leave the unit running
unattended.
•
Never attempt to bypass the thermostatic switch or fuses.
•
For replacement use fuses of same type and rating only.
•
The operation of a class 4 laser show laser is only allowed if the show is controlled by a skilled and
well-trained operator familiar with the data included in this manual.
•
The user is responsible for correct positioning and operating of the Galactic G300. The manufacturer
will not accept liability for damages caused by the misuse or incorrect installation of this device.
•
This device falls under protection class I. Therefore it is essential to connect the yellow/green
conductor to earth.
•
The laser will only work between 15-35ºC.
•
After 3 hours working, you must shut off the laser and let the laser diode cool off for 30 minutes,
otherwise the laser could be damaged and the warranty becomes void.
•
Repairs, servicing and electric connection must be carried out by a qualified technician.
•
WARRANTY: Till one year after date of purchase.
Operating Determinations
●
This device is not designed for permanent operation. Consistent operation breaks will ensure that the
device will serve you for a long time without defects.
●
The minimum distance between light-output and the illuminated surface must be more than 1 meter.
●
The maximum ambient temperature ta = 35°C must never be exceeded.
●
The relative humidity must not exceed 50 % with an ambient temperature of 30° C.
●
If this device is operated in any other way, than the one described in this manual, the product may
suffer damages and the warranty becomes void.
●
Any other operation may lead to dangers like short-circuit, burns, electric shock, crash etc.
You endanger your own safety and the safety of others!
