•
Select the “
>
”, and press the multi-selector for further information, LCD-display will show you
“Period : 036 ms” on the fourth line of the current display.
•
Use the multi-selector to select the”
?
”, then press the multi-selector for help information, LCD
will show you as below:
4.1.3 Data level ( Volt )
•
Use the multi-selector to select the
Data level (Volt)
item, and press the multi-selector to enter
further menu. LCD will show you the information about signal voltage.
( Here the connected DMX operator is also DC-1216
II
. )
•
Use the multi-selector to select the” ?”, then press the multi-selector for help information, LCD
will show you as below:
( Press the multi-selector again to exit from the current menu. )
4.2 DMX data—RX
•
Use the multi-selector to select the
DMX data—RX
item, and press the multi-selector to enter.
Three submenus are listed as below shows:
<
DMX data RX
1. Barchart display
2. Value display
3. Min/ max display
>
>
>
<
3. Data level
Reception may still
be possible with
lower level.
<
Data level ( Volt )
?
--good--
>
█
█
█
█
█
█
█
█
█
█
█
█
█
▪
▪
▪
Level = 4.44 V
<
2. Data timing :
Break min. 88
μ
s
MaB
min. 8
μ
s
Chantime
min. 44
μ
s
•
There are two display modes available:
Normal
mode and
Hold
Mode. This two modes can be
selected for application in the
DMX setting
item (submenu of
System setup
function mode).
For the
Normal
mode, when pushing the fader to the specific channel of the external operator (e.g.
DC-1216
II
), relevant channel value will change temporarily on the LCD display, conforming with
the position of the fader.
4
