•
The Start Code can be changed from 000 to 255 . The
Normal
mode and
Hold
mode can be
selected by the multi-selector as user’s requirement .
•
The “Input Pin” can be changed by the multi-selector between “-2 +3”
and
“+2 -3”. However,
this adjustment will comply with the receiving signals, which can be normal or reverse.
•
User can select the “
>
” at the fourth line on the screen, then press the multi-selector to confirm your
settings. If you select the”
?
”, and then press the multi-selector for help information, LCD will show
you as below:
<
1.
DMX setting
Startcode TX : 00-FF
Display Hold mode
Input normal : -2 +3
4.8.2 English
•
This unit supports 5 languages for convenient operation, including English, German, Spanish,
French and Italy. The default language version is
English
. User can use the multi-selector to
choose the desired language version, and then press the multi-selector to confirm.
Note:
The system language can be only
changed temporarily when powered on. If user restart the
unit, the system language is still the
English
version.
•
If user want to keep your language version setting always available for use, you can store the
setting into memory. For example, if you want to change the language version as
German
, firstly
you must set the language, and then use the multi-selector to enter the
DMX setting
submenu or
the
Display setting
submenu. After that, select the “
>
” at the fourth line of the screen, press the
multi-selector to
confirm your setting
. Then the German language version will be always available
for use even if you restart the unit.
4.8.3 Display setting
•
User can use the multi-selector to enter the
Display setting
menu, the LCD-display will show you:
>
>
>
>
<
Contrast_ level : 06
Back Light : off
Display : percent
? Confirm
•
The
Contrast level
of brightness can be set from 01 to 10 as user’s requirement.
The
Back Light
of the unit can be set as “on” or “off” status by using the multi-selector. If user set
the back light as “
on
” function, then the back light will go out in 15 seconds. Trigger the
multi-selector again, the back light will light up immediately. If user set the back light as “
off
”
function, then the back light will be always in the “off” status.
The
Display mode
can be selected as Decimal, Hexadecimal or Percent.
Note:
All the above settings can be done by using the multi-selector. If user want to save your
settings for available usage, you must select the “
>
” at the fourth line on the screen to confirm your
settings respectively. (If there didn’t confirm relevant setting, the settings will be canceled and be of
no effect when restart the unit next time.)
13
