SHOWTEC Data Flash Strobe, Manual

Page: 16 / 28

Ordercode: 40296
Data Flash Strobe
4. DMX Addressing
With this menu you can set the DMX address and control the DMX configuration.
01)
Press the MODE button and then the UP/DOWN buttons, until the display shows .
02) Press the SETUP button to open the menu. You can choose 512 different DMX addresses.
03) Press the UP/DOWN buttons to select the required address from .
Once you have set the desired DMX address, you can also see the DMX mode.
04) Press the SETUP button again to proceed to the channel mode settings.
05) Press the UP/DOWN buttons to choose one of the 3 channel modes. The available options are
.
5. Sound control Mode
01)
Press the MODE button and then the UP/DOWN buttons, until the display shows .
02) Press the SETUP button to open the menu.
03) Press the UP/DOWN buttons to set the sound sensitivity. The adjustment range is between
, from OFF to high sound sensitivity.
6. Dimmer
With this menu you can display the 8 sections of the device at once, or choose one or multiple sections.
01)
Press the MODE button and then the UP/DOWN buttons, until the display shows .
02) Press the SETUP button to open the menu.
03) Press the SETUP button to toggle through the menu and choose the desired sections.
04) Set the intensity of the sections by pressing the UP/DOWN buttons.
05) Be aware of the fact that, in order to display a section, you will have to set the Dimmer value (000-
255).
15