SHOWTEC Data Flash Strobe, Manual

Page: 15 / 28

Ordercode: 40296
Data Flash Strobe
Main Menu Options
1. Auto run
2. Built in programs
3. Slave mode
4. DMX addressing
5. Sound-controlled mode
6. Dimmer options
7. Settings
8. Info
On start-up, the device will show the current software version:
.
1. Auto Run Mode
With this menu you can start Auto Run mode.
01)
Press the MODE button and then the UP/DOWN buttons, until the display shows .
02) The Data Flash Strobe will now run all the built-in programs in a sequence.
2. Built-in Programs
With this menu you can you can set the built-in programs.
01)
Press the MODE button and then the UP/DOWN buttons, until the display shows .
02) Press the SETUP button to open the menu.
03) Press the UP/DOWN buttons to toggle through the 25 built-in programs.
04) Once you have selected one of the programs , press the SETUP button to
open the program.
05) Press the SETUP button several times to toggle between strobe frequency and program speed
settings.
06) Press the UP/DOWN buttons to change the values.
Program speed, from 001-100
Strobe frequency, from 00-99
3. Slave Mode
With this menu you can set the device as a slave.
01)
Press the MODE button and then the UP/DOWN buttons, until the display shows .
02) If the device has not been set to slave, it is automatically classified as a master device. All slave
devices will follow the master. If the device has been set to slave, it will react the same as its master
device.
14