8
Installation
Remove all packing materials from the Cameleon Spot 18-4 Q4. Check that all foam and plastic padding
is removed. Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Damages caused by non-observance are not subject to warranty.
Control Modes
FUNCTIONS:
There are 4 modes:
• Manual Mode
• Built-in programs
• Master/Slave
• DMX512
One Cameleon Spot (
Manual control
)
1.
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
When the Cameleon Spot is not connected by a DMX-cable, it functions as a stand-alone device.
Please see page 13 for more information about the Manual Color control.
One Cameleon Spot
(
Built-in Programs
)
1.
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
When the Cameleon Spot is not connected by a DMX-cable, it functions as a stand-alone device.
Please see page 14 for more information about the built-in programs.
Multiple Cameleon Spots (Master/Slave control)
1.
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
Use a 3-p XLR cable to connect the Cameleon Spot 18-4 Q4.
The pins:
1.
Earth
2.
Signal -
3.
Signal +
3.
Link the units as shown in (Fig. 3), Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
You can
use the same functions on the master device as described on page 13 and 14 (Built-in Programs or
Autorun
). This means on the master device you can set your desired operation Mode and all slave
devices will react the same as the master device.
