SHOWTEC Atmos B120, User Manual

Page: 10 / 17

8
Control Modes
There are 2 Modes: 1) Stand-alone
2) DMX512
One Atmos bubble machine ( Stand-alone )
1. Fasten the bubble machine onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Always use a safety cable (ordercode 70140 / 70141).
3. When the Atmos is not connected by a DMX-cable, it functions as a stand-alone device.
Multiple Atmos bubble machines (DMX Control)
1. Fasten the bubble machine onto firm trussing Leave at least 1 meter on all sides for air circulation.
2. Always use a safety cable (ordercode 70140 / 70141).
3. Use a 3-p XLR cable to connect the Atmos bubble machines and other devices.
4. Link the units as shown in (figure 4), Connect a DMX signal cable from the first unit's DMX "out" socket
to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units
.
5. Supply electric power: Plug electric mains power cords into each unit's IEC socket, then plug the
other end of the mains power cord into proper electric power supply sockets, starting with the first
unit. Do not supply power before the whole system is set up and connected properly.
Multiple Atmos bubble machines DMX Set Up
Fig. 4
Note : Link all cables and set dip switches before connecting electric power