7
Controller Backside
Fig. 2
24)
MIDI input port for external triggering of banks, scenes, chases, and blackout using a MIDI device
25)
DMX polarity switch May be used to change signal polarity
26)
DC Input jack Main power feed
27)
Strobe connector Showtec Mono Strobe ¼” connector for built in strobe controller
28)
Fog connector Showtec fog controller jack mono
29)
ON/OFF power switch Turns the controller on and off
30)
3-pin DMX output connector
31)
5-pin DMX output connector
Installation
Remove all packing materials from the SM-8/2. Check that all foam and plastic padding is removed.
Screw the equipment into a 19" rack. Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Summary of Contents for 50700
Page 1: ...SM 8 2 ORDERCODE 50700...
Page 19: ......
