9
Ordercode: 42578
Powerspot 10 SW White
Control Modes
There are 6 modes:
•
Auto run
•
Built-in programs
•
Static Color (dimmer)
•
Sound-controlled
•
Master/slave
•
DMX-512 (3CH, 6CH or 7CH)
One Powerspot 10 SW (Auto Run Mode, Built-in programs and Static Color Mode)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Plug the end of the electric mains power cord into a proper electric power supply socket.
03)
When the Powerspot 10 SW is not connected with a DMX cable, it functions as a stand-alone
device. Please see pages 14 and 15 for more information about Auto Run Mode, the Built-in
programs and Static Color Mode.
One Powerspot 10 SW (Sound-controlled)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Plug the end of the electric mains power cord into a proper electric power supply socket.
03)
Turn on the music. If the device is set to sound-control, then the Powerspot will react to the beat of
the music. Please see page 15 for more information about the sound-control options.
Multiple Powerspots 10 SW (Master/Slave control)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Always use a safety cable (ordercode 70140 / 70141).
03)
Use a 3-p XLR cable to connect the Powerspots and other devices.
The pins:
1.
Earth
2.
Signal (-)
3.
Signal (+)
04)
Link the units as shown in Fig. 03, connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units. You can
use the same functions on the master device as described on pages 14 and 15 (Auto run, Built-in
Programs, Static color). This means you can set your desired operation mode on the master device
and all slave devices will react the same as the master device.
Multiple Powerspots 10 SW
(
Master/Slave control)
Fig. 03
