14
2.2 Functionality
2.2.1 Manual mode
The manual mode allows direct control of all scanners. You can adjust them using
the channel sliders and change attributes.
1) Press the AUTO DEL button until the AUTO LED goes out.
2) Select a SCANNER button
3) Move the sliders to change the device attributes. Press the TAP/DISPLAY button
to toggle the output display on the LED display between DMX values (0-255) and
percent (0-100).
Comments:
All changes made in manual mode are temporary and are not saved.
2.2.2 Calling up scenes or chases
This instruction assumes that you have already recorded scenes and chases on the
controller. Otherwise, skip this section and continue with the Programming section.
Playing the scene
1)
Select one of the 30 banks with the BANK UP/DOWN buttons.
2) Select a SCENE button (1~8) to display.
3) Move the sliders to change the scene setting.
4) Press the selected SCENE button (1-8) again to end the scene. The LEDs of
each SCENE will turn off.
Playing a Chase
1) Press one of the 6 CHASE buttons.
2) Press the TAP/DISPLAY button to show the scene steps on the display.
3) Use the BANK UP/DOWN buttons to view the sequence of scenes in the chase.
Comments:
Make sure that you are still in MANUAL mode.